ServicesPool Repair
Pool Repair in Sun Lakes
When the pump hums but won't start, the filter leaks at the clamp or the heater throws a code, we find the cause and fix it. Power is shut off and checked before we open anything, and you get a plain answer on repair or replace.
Repairs done with the power off and the facts on the table
Pool repair covers the parts that keep your water moving, filtered and warm: pumps, motors, filters, valves, heaters, timers and the plumbing at the equipment pad. Most problems start small. A worn shaft seal drips for weeks before the motor bearings go. A cracked filter tank weeps before it splits under pressure.
Pool equipment puts water, high voltage and pressurized tanks a few feet apart. So every repair starts as a safety job. We switch off the breaker, test that the circuit is dead and bleed pressure off the filter before we loosen a single clamp. Then we find the real cause, show you what we found and tell you whether a repair makes sense or the part is finished.
Pumps here run long hours through the summer, and that heat is hard on seals, O-rings and wiring. Catching a failing part early usually means a smaller repair and a pool that stays clear.
What our pool repair work covers
Pump and motor repair
We replace shaft seals, bearings, capacitors and impellers, and clear debris jammed in the impeller. If a motor is burned out, we'll say so and walk you through replacement with our equipment installation service.
Filter repair
Cracked tanks, broken lids, worn clamp bands, torn grids and stuck multiport valves. A filter tank holds real pressure, so we never touch one until the gauge reads zero and the air relief is open.
Valves and plumbing at the pad
Leaking unions, cracked fittings, worn diverter valves and glued joints that have let go. We cut out the bad section and replumb it clean so it doesn't drip again next month.
Heater troubleshooting
We check flow, pressure switches, ignition and error codes. On gas heaters we check for gas odor and venting problems before anything else.
Timers and automation
Dead timers, bad relays and control panels that stopped talking to the pump. We sort out the wiring and get your schedule running again.
A safety check while we're there
We look at the bonding wire, test the GFCI and check the condition of your drain covers. If something isn't safe, you hear about it the same visit.
Signs your pool needs a repair
The pump hums but won't start
Often a bad capacitor or a seized motor. Shut it off. Running it like that can overheat the motor and turn a small fix into a big one.
Water dripping under the pump
That's usually the shaft seal. Left alone, water works into the motor bearings and windings.
Filter pressure is way off
Pressure climbing fast after a cleaning, or dropping to nothing, points to a clog, a broken part inside the tank or a valve problem.
Air in the pump basket
A half-empty basket or bubbles at the returns means the pump is pulling air. A worn lid O-ring or a cracked fitting on the suction side is the usual cause.
The breaker or GFCI keeps tripping
Don't keep resetting it. A ground fault near water is serious. Leave it off and give us a call.
The heater won't fire
Error codes, clicking with no flame or a heater that runs but never warms the water. Low flow is often the real cause, and we check that first.
How a repair visit goes
- 1
A call and a free quote
Tell us what the equipment is doing. We'll tell you what's likely wrong and what's safe to leave on until we get there. The quote is free.
- 2
We make it safe first
Breaker off, circuit tested dead, filter pressure released. We ask that kids and pets stay clear of the equipment pad while we work.
- 3
We find the cause
We test and take apart what's needed, take photos of what we find and explain it in plain words. If repair costs come close to a new part, we tell you.
- 4
Fix, test and clean up
We make the repair, restore power and watch the system run. We check for drips, pressure and flow, test the GFCI and haul off the old parts.
What affects the cost of a pool repair
We price a repair after we see the equipment, not before. You get the parts and labor spelled out, and no work starts until you say okay.
- The part that failed
- A capacitor or an O-ring is a small job. A motor, a filter tank or a heater component costs more in parts and time.
- Age and make of the equipment
- Older or discontinued models can need adapters or harder-to-find parts.
- Room to work at the pad
- A cramped pad with tight plumbing means more cutting and gluing to get at the problem.
- What else turns up
- Corroded wiring or a broken bonding wire found during the repair has to be fixed before the system is safe to run. We show you before we add it.
- Repair or replace
- When a fix would cost close to new equipment, we lay out both options so you can choose.
Pool repair questions
Something not covered here? (480) 605-3328
Can I keep running the pump if it's leaking?
A slow drip from the seal can usually run a short while. If water is spraying, pooling near the motor or the breaker is tripping, shut it off at the breaker. Water and the motor's electrical parts don't mix.
The breaker keeps tripping. Should I just reset it?
No. A breaker or GFCI that trips again and again is telling you something is wrong. Leave it off, keep people away from the pad and call us. We'll find the fault before anything gets switched back on.
Will you just tell me to buy new equipment?
Not if a repair makes sense. Plenty of pumps and filters have years left after a new seal or lid. When a part is truly worn out, we show you why and let you decide.
Do you work on equipment you didn't install?
Yes. We work on the common residential pumps, filters, heaters and timers you'll find at most homes. If a part is hard to get for an older model, we'll tell you up front.
How long does a repair take?
Many repairs are done in one visit when the part is on hand. Some parts have to be ordered, and we'll let you know if that's the case. In the meantime we leave the system in a safe state.
Does someone have to be at the house during the repair?
You don't have to stay home for most jobs. Leave the gate unlocked, keep your pets indoors and make sure we can reach the equipment and your electrical panel. If you're away, we'll phone you afterward and explain what we found and what we fixed.
Get your pool running safely again
Tell us what the equipment is doing and we'll give you a free quote by phone. We'll also tell you what's safe to leave on until we get there.